CONSTRUCTION SPECS: CARBINE & RIFLE BUFFER SPRINGS:
ASTM Grade A877 Certified Valve Quality Chrome Silicon Wirestock
Heat Treated, Stress Relieved and Dual Stage Shot-Peened post winding (Our springs really ARE shot-peened)
Impregnation / Plating with Re-Micronized Molybdenum Disulfide formulation
Hard plastic tube packaging for protected transport and easy storage
Optional Cryogenic Processing available upon request
Shortened “lock time” for faster sight recovery and platform stability
Consistent spring pressure throughout the duty cycle of the spring, resulting in fewer malfunctions related to spring operation. (Especially Type III malfunctions)
Improved & consistent cyclic operation. Spring will not change performance for many hundreds of thousands of rounds.
Greater resistance to heat induced performance degradation
Reduced cyclic rate with Enhanced or Extra Power springs and reduce / eliminate bolt bounce with optimal spring / buffer weight selection.
Reduced operating cost as replacement springs are not needed during the life of your upper receiver assembly. Less downtime and fewer trips to the armorer for spring replacement, in fact, this will most likely be the only buffer spring you will ever need for the duty cycle of your carbine or rifle!
Correct spring selection works reliably, consistently, and virtually indefinitely in all properly built and maintained AR platforms.
“WHITE Spring”: STANDARD Power Buffer Spring. Equivalent spring load to a “fresh” Mil-Spec M4 Carbine Spring. This spring will perform reliably in any properly configured and maintained 5.56 Carbine, if you wish to maintain the performance of a “fresh” Mil-Spec load spring without concern for replacement. This is the best choice for shooters and purists that wish to maintain the performance of most factory supplied NEW Mil-Spec springs, but do not wish to be concerned with frequent replacement of same or do not have the time or inclination to seek enhanced performance options. The “WHITE” spring is recommended for 10.0″-11.0″ SBR’s with H2 Buffers, 1st Gen M&P’s, older RRA’s with under 18″+ BBL’s, early generation Colt 6920 LE’s, 5.56 & 6.8 SPC 7.5″-8.5″ BBL Piston Guns with H2 Buffers, with few exceptions, most .300 AAC Platforms, longer carbine barrels using intermediate or rifle length gas, and when training with SRTA and other low power and light charged “budget” rounds. Color Coded WHITE. [EXCEPTIONS: With SBR’s which are seriously overgassed firing suppressed, (e.g. 10.3″ HK 416’s), a RED or ORANGE along with a hydraulic buffer is often used with great success.]