Flat Rate Shipping! Only $10 on all orders
Close
Waterford, MI 48327 7160 Highland Rd.
248-568-1708 ockie@gerbranddefense.com
Open hours: Mon - Fri 9am - 7pm, Sat 9am - 6pm
Out of stock

FORWARD CONTROLS DESIGN PF-40 TAKEDOWN AND PIVOT PINS

$33.25

Out of stock

Want to be notified when this product is back in stock?

UPC: 680665827107 SKU: FCDPF40 Category: Tag: Product ID: 2115

Description

PF-040 (Pins, Forward Controls, 0.040) is a set of elegantly simple, and superbly crafted AR15/M16 pivot and take down pins. Machined from 17-4 PH SS bar stock and QPQ finished, these pins are 0.040 longer than TDP spec pivot and take down pins.
PF-040 pins can be aptly described as “reverse extended”, in that they’re longer on the left side of the receiver, the additional length of the take down pin doesn’t interfere with ambidextrous safety operation. When PF-040 pins are pushed in from the left side, the +0.040 transforms to extra length and grasping area on the right side pin head, which combined with their silky smoothness, makes pulling the pin a cinch.
PF-040 has the same elegant and unadorned pin heads design that is in line with our design philosophy which prioritizes functionality over aesthetics. PF-040 right side pin heads (when installed on a receiver, with the muzzle pointing away) are flat, with a small 45 degree chamfer. Serrations or dimples on the right pin head would be useless, so they’re completely plain. There is a small dimple on the other side of the pin head, the tip of bullets (up to 9mm) can be used to push the pins in on tight fitting receivers.
PF-040 can be purchased with the optional takedown/pivot detents (4) and springs (3) kit. The odd numbers of included components probably deserve some explanation. Even for experienced AR builders, it’s not uncommon to launch the pivot pin detent into the twilight zone. It’s also fairly easy to bend the take down pin detent spring during installation of the end plate and castle nut. So the optional detents and spring kit includes 4 detents and 3 springs to preempt losses and damages. If you don’t end up needing and using all of them at once, the kit is reasonably priced, and always good to have on hand to grow into another AR 🙂
NOTE:
PF-040 may not work “PDW” stocks that have bars overlapping the take down pin holes.
PF-040 may be shipped with the old PWA-040 instructions card, the name under which it was sold up till Feb of 2019. The pins are identical, Forward Controls acquired the rights to the pins in Feb. of 2019.

You may also like…